Tips of changing the washing machine bearing

After the washing machine bearing is removed, first observe whether there are cracks, rust, scars on the rolling element, the inner ring and outer ring of the bearing. Then hold the inner ring of the bearing by hand and level the bearing, and rotate the outer ring of the bearing with the other hand. If the bearing is good, the outer ring should rotate smoothly and gradually decelerate to stop. There is no vibration or obvious stagnation during the rotation. After the rotation, the outer ring does not reverse. If the bearing is defective, noise and vibration will appear when it rotates. It will be abrupt like a brake when it stops, and it will reverse backwards seriously. Such bearings should be replaced.　　
The radial clearance of the washing machine bearing is 0.01 mm-0.02 mm. Push the inner ring in all directions. If the gap is felt when pushing, then the bearing wear is severe.
Before installing the washing machine bearing, it should be cleaned and checked for flexibility and smoothness, and greased. Then, ZYS washing machine bearing is placed on the journal, and a sleeve is used to hold the inner ring of the bearing. The upper end of the sleeve is iron-plated and hammered until the bearing is in place. When knocking, pay attention to the fact that the bearing can not be skewed, and the tap should be facing the axial direction.

Signs That You Need To Change Washing Machine Bearings

1. Noise

After long operation of washing machine, the bearings in the drum are eventually going to wear out. You can tell this immediately when you hear noise appearing from the drum during the operation. You can do a quick inspection of the drum. 

2. Oil stains on the clothes

If there are oil on the clothes after each washing cycle, it means that your main seal on the bearings is also worn and should be replaced. Despite this, you'd better change the bearings as well since they could collapse.

It's important to remember to put the right seal around each bearing as well. The wrong seal could end up leaking water on the new bearings, hence causing part failure once again.

Products features of Washing Machine Bearings:

· Bearing supported, shipped grease lubricated and protected against dust larger than .012" (.3mm) diameter.

· Available with additional lip seals (- 2RS) for enhanced sealing, as well as, with a keyway on the inner ring (-P) or the inner and outer ring (-PP) for additional ease of installation.

· Operating temperature: 21 to 140°F (-6 to 60°C)

· Special grease available for operating temperatures: -40 to 212°F (-40 to 100°C)

Contact Person: Mr.Dong

Address: No.1 Jilin Road, Luoyang City,Henan Province,China

Zip:471039

Tel: +86-379-6488 1209

Fax: +86-379-6488 1529

Mobile No:+86 139 3792 3793

Website: www.zys.com.cn

              www.zysbearing.com
E-mail: zysdong@gmail.com
Skype: zysdongoffice

QQ: 18937963793